SolarOS 4.17.7 manual · command
wifi
Open the Wi-Fi display TUI when launched from the display shell.
Usage
| Usage | Description |
|---|---|
wifi | Open the Wi-Fi display TUI when launched from the display shell. |
wifi status | Show station/AP/NAT state and the current/next boot setting. |
wifi enable | Save Wi-Fi enabled for the next boot. The current boot is unchanged. |
wifi disable | Save Wi-Fi disabled for the next boot. The current boot is unchanged. |
wifi on | Start Wi-Fi station mode and connect to remembered networks. |
wifi off | Stop station/AP networking; an active ESP-NOW lease retains the radio. |
wifi scan | Scan access points. |
wifi connect [ssid [password]] | Connect and save/update a station profile. |
wifi disconnect | Disconnect station mode. |
wifi known | List remembered station profiles. |
wifi forget [ssid|all] | Remove one or all remembered station profiles. |
wifi repeater | Show L2 IPv4 repeater state, upstream, downstream, learned clients, and forwarding counters. |
wifi repeater on | Repeat the current or preferred saved network with the same SSID and password on the same IPv4 subnet. |
wifi repeater off | Stop L2 forwarding and the downstream AP while retaining the upstream station. |
wifi ap [status] | Show SoftAP status. |
wifi ap on [ssid [password [open|wpa|wpa2|wpa/wpa2]]] | Start and save SoftAP settings. |
wifi ap off | Stop SoftAP. |
wifi nat [status|on|off] | Advanced control for IPv4 NAT on the SoftAP interface. Prefer network router. |